2 reset trip – Lenze 8615E User Manual
Page 84
[ C o d e
Parameter (Factoty setting is printed in bold)
Function
be
via CO01
Function
be activated via terminals
CO01
Acceptance
[SH + PRG]
Except for the
“Enable JOG frequencies”, “Enable additional
acceleration and
times” and “Select Parameter
every
function
only be assigned to one terminal. If you want to re-assign
an input, the previous programming is lost.
A function
only be assigned to one input. A double assignment is
not possible.
5.2
of the freely assignable digital inputs
5.2.1 Set TRIP
The
receives a TRIP message via the assigned input.
the
Cl 19 and Cl 20, you
the monitoring
of the input such that in
of fault indications
l
these indications are ignored,
l
TRIP is activated or
l
a warning is activated.
Select the TRIP set input by
Cl 19 -0- and
the
function via Cl 20 (see page 99).
(Factory setting is printed in bold)
Preselection:
Input TRIP-Set
M o n i t o r i n g
P T C i n p u t
Output power t monitoring)
Function for
For Cl19 -O-.
M o n i t o r i n g
Monltoring
sets trip
Monitoring
sets waming
For
Rated power for temperature range up
to 50°C
Increased power for temperature
range up to 45°C
Maximum power for temperature
r a n g e u p t o 4 0 ° C
Acceptance
SH PRG
SH + PRG
5.2.2 Reset TRIP
A fault
a TRIP is automatically displayed
CO67
and is indicated e.g. via the relay output. To reset the TRIP
memory, you
use the input
is assigned to the TRIP reset
function or press the keys SH + PRG.
82