13 loop control with adaption, Caution – Lenze 8615E User Manual
Page 121
9.13
Loop control with
adaption
others, a loop control is required for the transport of
material by means of two conveyor belts. The
occurs
between the two conveyor belts is kept
by the loop
control.
To ac:tivate the loop control the
89 must be set to -0- but
only with activated controller inhibit.
Usually the field frequency
control is not used for the loop
control. Therefore
2V has to be entered
as
setpoint. Afterwards the
control has to be set such
that the
of the field frequency CO64 corresponds to the act.
value of the field frequency
The
controller must be set in the same way as the
controller.
Caution!
The
of rotation may be reversed if the loop controller is set
too high, the ouput is e.g. negative and the
frequency input
is positive.
dancer-pos.
c o n t r o l l e r
Parameter (Factory setting is printed in
of the dancer-pos. controller
o u t p u t w i t h t h e m a i n
controller overlav
Acceptance
[SH + PRG]
119