Lenze SCD Series - Manual (Page 50)

47
P58 KEYPAD AND PROTECTION STATUS
This indicates the status of the buttons on the keypad, and the status of the protective circuitry in the
drive, using the horizontal segments of the LED. An illuminated segment indicates that the
corresponding button is pressed, or the protective circuit is active. See the diagram below:
CHARGE
RELAY
TB-1
TB-12
TB-13A
TB-13B
TB-15
TB-14
TB-13C
FCLIM
Mode
OUTPUT
FAULT
!
"
NOTE: FCLIM is an abbreviation for Fast Current Limit.
P59 TB-30 ANALOG OUTPUT
This displays the level of the analog output signal at TB-30. A reading of 100% indicates that the
output is 10 VDC.
P60 TB-31 ANALOG OUTPUT
This displays the level of the analog output signals at TB-31. A reading of 100% indicates that the
output is 10 VDC.
P85 MOTOR RATED RPM
When using the DeviceNet interface, this must be set to match the nameplate RPM of the motor.
P86 MOTOR RATED CURRENT
When using the DeviceNet interface, this must be set to match the nameplate full load amperage
(FLA) rating of the motor.