Lenze SCD Series - Manual (Page 87)

84
DNET Par. ID 25 - SPEED REFERENCE:
0 - Local speed reference (SCD drive speed selection: keypad, presets, analog)
1 - Network speed reference
Object Map - AC Drive Object 0x2A-1-4
NOTE: Parameter IDs 20-25 will reset to 0 when power is cycled or the drive is reset.
DNET Par. ID 26 - NETWORK COMMAND FREQUENCY: Sets the drive command frequency
if parameter ID #25 is set to NETWORK REFERENCE (0.1 Hz resolution).
DNET Par. ID 27 - CONTROL SOURCE (READ ONLY)
0 - Local control
1 - Control from the Network
Object Map - Control Supervisor Object 0x29-1-15
DNET Par. ID 28 - SPEED REFERENCE SOURCE (READ ONLY)
0 - Local speed reference
1 - Network speed reference
Object Map - AC Drive Object 0x2A-1-29
DNET Par. ID 29 - DRIVE ACTUAL DIRECTION (READ ONLY)
0 - Forward
1 - Reverse
DNET Par. ID 30 - RUN STATUS (READ ONLY): See table below:
DNET Par. ID 31 - SPEED SOURCE (READ ONLY): See table below:
NO. NO. NO. STATUS
0 FAULT LOCKOUT 4 DC BRAKE 8 DECELERATION
1 FAULT 5 RUN AT 0 Hz 9 CURRENT LIMIT
2 START PENDING 6 RUN 10 DECEL OVERRIDE
3 STOP 7 ACCELERATION 11 LOWER ON SEQUENCE
STATUS STATUS
RUN STATUS
NO. NO. NO.
0 KEYPAD 5 PRESET SPEED #3 10 JOG SPEED
1 0 - 10 VDC 6 PRESET SPEED #4 11 MOP SPEED
2 4 - 20 mA 7 PRESET SPEED #5 12 DEVICENET
3 PRESET SPEED #1 8 PRESET SPEED #6
4 PRESET SPEED #2 9 PRESET SPEED #7
SOURCE STATUS
SPEED SOURCE
STATUS