Lenze SCD Series - Manual (Page 73)

70
ID NO. PARAMETER OBJECT MAPPING
1 OUTPUT FREQUENCY (0.1 Hz) 0x0F-1-1
2 OUTPUT VOLTAGE (V) 0x2A-1-17
3 OUTPUT CURRENT (100mA) 0x2A-1-9
4 OUTPUT POWER (W) 0x2A-1-15
5 INPUT VOLTAGE (V) 0x2A-1-16
6 COMMANDED FREQUENCY (0.1 Hz) 0x0F-6-1
7 PRESENT FAULT DNET CODE 0x29-1-13
8 PRESENT FAULT NAME 0x0F-8-1
9 - 16 RESERVED
17 BUS OFF ERROR 0x03-1-3
18 BUS OFF COUNT 0x03-1-4
19 DEVICENET IDLE MODE 0x0F-19-1
20 CONTROL SOURCE 0x29-1-5
21 RUN FORWARD 0x29-1-3
22 RUN REVERSE 0x29-1-4
23 FAULT RESET 0x29-1-12
24 DEVICENET PRESET COMMAND 0x0F-24-1
25 SPEED REFERENCE 0x2A-1-4
26 NETWORK REFERENCE FREQUENCY 0x0F-26-1
27 STATUS OF RUN/STOP CONTROL SRC 0x29-1-15
28 STATUS OF SPEED REFERENCE 0x2A-1-29
29 ACTUAL DIRECTION 0x0F-29-1
30 RUN STATE 0x0F-30-1
31 SPEED SOURCE 0x0F-31-1
32 RESERVED
33 AT REFERENCE STATUS 0x2A-1-3
34 RESERVED
35 COS STATUS 0x0F-35-1
36 COS MASK 0x0F-36-1
37 RESERVED
38 KEYPAD COMMAND FREQUENCY 0x0F-38-1
39 RESERVED
40 ACT EEPROM VERSION - PARAMETER VERSION ID NUMBER 0x0F-40-1
PARAMETER OBJECT INSTANCE (PARAMETER LIST)
NOTE: THE SAME PARAMETERS ARE PRESENT IN THE EDS FILE