Lenze SCD Series - Manual (Page 96)

93
DNET Par. ID 150 - DEVICENET DIAGNOSTICS (ACT Parameter C10) (READ ONLY):
See tables below:
NO.
0 LOCAL CONTROL
1 NETWORK CONTROL
2 ACT PARAMETER 14 - CONTROL SET TO "NETWORK ONLY" BUT NETWORK
CONTROL IS NOT SET.
DESCRIPTION
LEFT DIGIT - CONTROL STATUS
NO. NO.
0 NETWORK OFF 5 NETWORK CONNECTED
1 NETWORK NOT CONNECTED 6
2 NETWORK CONNECTION TIMEOUT 7
3 COMMUNICATION FAULTED 8 DUPLICATE MAC ID FAILURE
4 9 NETWORK CRITICAL LINK FAILURE
DESCRIPTION DESCRIPTION
MIDDLE DIGIT - NETWORK STATUS
NO. NO.
0 I/O CONNECTION OFF 5 I/O ACTIVE
1 I/O CONNECTION IDLE STATE 6
2 7
3 I/O FAULTED 8
4 9 I/O CRITICAL ERROR
DESCRIPTION DESCRIPTION
RIGHT DIGIT - I/O STATUS
NO. NO.
0 NON-STANDARD MOTOR 6 WOUND ROTOR INDUCTION
1 PM DC MOTOR 7 SQUIRREL CAGE INDUCTION
2 FC DC MOTOR 8 STEPPER MOTOR
3 PM SYNCHRONOUS MOTOR 9 SINUSOIDAL PM BL
4 FC SYNCHRONOUS MOTOR 10 TRAPEZOIDAL PM BL
5 SWITCHED RELUCTANCE
DESCRIPTION DESCRIPTION
MOTOR TYPES
DNET Par. ID 149 - DEVICENET MOTOR TYPE (ACT Parameter C09): See table below: