Lenze SCD Series User Manual
Page 85
82
DNET ID 126 ACT Par 86 MOTOR RATED CURRENT
DNET ID 127 ACT Par 87 MOTOR RATED VOLTAGE
DNET ID 128 ACT Par 88 MOTOR RATED FREQUENCY
DNET ID 129 ACT Par 89 DRIVE RATED CURRENT
DNET ID 130 ACT Par 90 DRIVE RATED VOLTAGE
DNET Par. ID 6 - COMMANDED FREQUENCY (READ ONLY): Actual commanded frequency
(speed) of the drive (0.1 Hz resolution).
DNET Par. ID 7 - PRESENT FAULT DNET CODE (READ ONLY): Shows the current fault code.
Refer to the table in Section B.5.9.
DNET Par. ID 8 - PRESENT FAULT NAME (READ ONLY): See the table below:
DNET Par. ID 9 through 16 - Reserved.
DNET Par. ID 17 - BUS OFF ERROR: Determines how the Communication Section processes a
CAN Bus OFF condition.
0 - Hold CAN chip in bus off state when bus off is detected.
1 - Tries to reset the CAN and continue communication.
DNET Par. ID 18 - BUS OFF COUNT: Number of times the CAN peripheral went into bus off state.
Counter maximum value is 255. Any write into this parameter resets the counter to 0.
DNET Par. ID 19 - DEVICENET IDLE MODE: This parameter is used to set the action the SCD
drive should perform when the connection is closed (set to idle state) and drive is still in DNET
control.
0 - STOP the drive if IDLE mode
1 - Hold last state if IDLE mode (WARNING! Make sure it is safe to operate this way!)
NO.
NO.
NO.
0
NO FAULT
10
INTERNAL 1 EPM
20
SINGLE PHASE INPUT
1
OUTPUT FAULT
11
INTERNAL 2
21
INCOMPATIBLE EPM
2
HIGH TEMP.
12
INTERNAL 3
22
DYNAMIC BRAKE
3
HIGH BUS VOLTAGE
13
INTERNAL 4
23
DEVICENET FAULT
4
LOW BUS VOLTAGE
14
INTERNAL 5
24
DNET TRIGGER FAULT
5
MOTOR OVERLOAD
15
INTERNAL 6
25
RESERVED
6
CONTROL FAULT
16
INTERNAL 7
26
RESERVED
7
EXTERNAL FAULT
17
INTERNAL 8
27
RESERVED
8
OEM DATA FAILED
18
INTERNAL 9
9
START ERROR
19
INTERNAL 10
FAULT NAME
FAULT NAME
FAULT NAME
PRESENT FAULT NAME