Lenze SCD Series - Manual (Page 86)

83
DNET Par. ID 20 - CONTROL SOURCE: Must be set to NETWORK CONTROL before network
RUN FWD or RUN REV will be accepted.
0 - Local control (from SCD terminals)
1 - NETWORK CONTROL (WARNING! Make sure it is safe to operate the drive!)
Object Map - Control Supervisor Object 0x29-1-5
If this parameter (attribute) is set, the RUN STOP events are controlled by a combination of RUN
FWD and RUN REV attributes (parameters) shown in the table in Section B.5.9.
DNET Par. ID 21 - RUN FORWARD: Request RUN Forward if Control is set to NETWORK
0 - STOP running FORWARD
1 - RUN FORWARD (WARNING! Make sure it is safe to operate the drive!)
Object Map - Control Supervisor Object 0x29-1-3
DNET Par. ID 22 - RUN REVERSE: Request RUN Forward if Control is set to NETWORK
0 - STOP running REVERSE
1 - RUN REVERSE (WARNING! Make sure it is safe to operate the drive!)
Object Map - Control Supervisor Object 0x29-1-4
NOTE 1: To run in reverse direction, Parameter #17 - ROTATION must be set to 2 (FORWARD and
REVERSE)
NOTE 2: Local stop command (opening connection between terminals 1 and 4) overrides RUN/
STOP command from DeviceNet
TM .
DNET Par. ID 23 - FAULT RESET: Transition from 0->1 clears the SCD fault.
0 - No Action
0 -> 1 - Fault RESET
Object Map - Control Supervisor Object 0x29-1-12
DNET Par. ID 24 - PRESET COMMAND: Allows preset speed reference while in network control.
0 - Local speed reference (keypad, analog)
1 - Preset #1 (ACT parameter #31)
2 - Preset #2 (ACT parameter #32)
3 - Preset #3 (ACT parameter #33)
4 - Preset #4 (ACT parameter #34)
5 - Preset #5 (ACT parameter #35)
6 - Preset #6 (ACT parameter #36)
7 - Preset #7 (ACT parameter #37)
NOTE: Preset speeds are only active when DeviceNet control is set but NOT network reference. If
network reference is set, preset speed control is ignored.
WARNING!
Make sure it is safe to operate the SCD Series drive from the network! Damage to equipment and/or
injury to personnel can result from unattended/improper operation.