Lenze SCD Series - Manual (Page 89)

86
DNET Par. ID 37: Reserved.
DNET Par. ID 38 - KEYPAD COMMAND FREQUENCY: Allows the keypad speed (which is
normally accessed using the V and W buttons on the front of the drive) to be changed through DeviceNet.
This speed can be used as Preset Speed #0 in Output Assembly 103 and Parameter 24.
DNET Par. ID 39: Reserved.
DNET Par. ID 40 - SCD DRIVE PARAMETER VERSION (READ ONLY): Displays the parameter
version number of the drive (example: 322). This is the same number that the drive displays when
power is applied.
DNET Par. ID 41 through 139: Correspond to ACT Parameters 1 through 90 and are described in
Section 15.0 - DESCRIPTION OF PARAMETERS.
DNET Par. ID 140 - DEVICENET NODE ADDRESS (ACT PARAMETER C00): DeviceNet
address 0-63. Does not take effect until power to the drive is cycled.
DNET Par. ID 141 - DEVICENET BAUD RATE (ACT PARAMETER C01)
0 - 125kbps
1 - 250kbps
2 - 500kbps
DNET Par. ID 142 - ACTION ON LOSS OF DEVICENET (ACT PARAMETER C02)
0 - FAULT & STOP - Trigger the 'JF' Network fault if drive is running.
1 - IGNORE (do not do anything)
2 - AC TECH specific - Switch OFF control to TERMINAL and do not do anything (if drive was
running, it will keep running in terminal mode)
WARNING! For settings 1 and 2, make sure it is safe to operate this way!
Object Map - Control Supervisor Object 0x29-1-16
DNET Par. ID 143 - DEVICENET OUTPUT ASSEMBLY SELECTION (ACT PARAM. C03):
Select the output assembly, consumption size, and path for polled I/O connection.
1 = "1 Basic Contactor" - ODVA SPECIFIED
2 = "2 Basic Overload" - ODVA SPECIFIED
3 = "3 Basic Motor Starter" - ODVA SPECIFIED
4 = "4 Ext. Contactor" - ODVA SPECIFIED
5 = "5 Ext. Motor Starter" - ODVA SPECIFIED
6 = "20 Basic Speed Ctrl" - ODVA SPECIFIED
7 = "21 Ext. Speed Ctrl" - ODVA SPECIFIED
8 = "100 Ext.Speed Ctrl Hz" - AC TECH specific (Same as Assembly 21, except speed is in Hz)
9 = "103 Preset Speed Ctrl" - AC TECH specific