MacDon CA20 Operators Manual - Manual (Page 11)

ADAPTER AND CASE IH 7010, 8010
Form 169009 9 Model Year - 2009
5 ADAPTER ATTACHMENT/
DETACHMENT ON
COMBINE
The adapter is configured to each particular
model of combine at the factory.
These combines are:
COMBINE SECTION
Case IH 7010, 8010 5.1
Case IH 2300, 2500 Series 5.2
John Deere 60, 70 Series 5.3
John Deere 50 Series 5.4
Cat Lexion 400, 500(R) 5.5
New Holland CR, CX 5.6
AGCO Gleaner R, A Series
Challenger 660, 670, 680B
Massey 9690, 9790, 9895 5.7
This section includes instructions on attaching
and detaching the Model CA20 Combine
Adapter with a header to the combines listed
above.
IMPORTANT
Ensure applicable functions (AHHC,
Draper Header Option, Hydraulic Center
Link Option, Hydraulic Reel Drive, etc.)
are enabled on the combine and combine
computer. Failure to do so may result in
improper header operation.
5.1 CASE IH 7010, 8010
5.1.1 ATTACHMENT
a. Slowly drive combine up to adapter until feeder
house saddle (A) is directly under the adapter
top cross member (B).
b. Raise feeder house slightly to lift adapter,
ensuring feeder saddle is properly engaged in
adapter frame.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
c. Lift lever (C) on adapter at left side of feeder
house and push handle (D) on combine to
engage locks (E) on both sides of the feeder
house.
d. Push down on lever (C) so that slot in lever
engages handle to lock handle in place.
e. If lock (E) does not fully engage pin on adapter
when (C) and (D) are engaged, loosen bolts (F)
and adjust lock as required. Re-tighten bolts.
f. Connect combine hydraulic quick coupler to
receptacle (G) on adapter as follows:
1. Open cover (H).
2. Push in lock button (J) and pull handle (K)
to full open position.
(continued next page)
A
B
K
H
J
G
D
C
E
F