MacDon CA20 Operators Manual - Manual (Page 40)

ADAPTER AND AGCO
Form 169009 38 Model Year - 2009
c. Raise feeder house to lift adapter, ensuring
feeder house saddle (F) and alignment pins are
properly engaged in adapter frame.
d. Raise header slightly off the ground.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
e. Engage lugs (A) with adapter using lock handle
(B).
f. Connect adapter hydraulic quick coupler to
combine receptacle as follows:
1. Pull handle (G) to release coupler (H) from
adapter.
2. Push handle (J) on combine to full open
position.
3. Clean mating surfaces of coupler and
receptacle if necessary.
4. Position coupler (H) onto combine
receptacle (K) and pull handle (J) to fully
engage coupler into receptacle.
5. Rotate disc (L) on adapter drive-line
storage hook and remove drive-line from
hook.
(continued next page)
F
J
K
H
G
L
ALL EXCEPT GLEANER ‘R’ SERIES
B
GLEANER ‘R’ SERIES
B
A