MacDon CA20 Operators Manual - Manual (Page 67)

OPERATION
Form 169009 65 Model Year - 2009
b. Check that adapter float linkage is on
downstops (washer (A) and nut (B) cannot be
moved).
c. Loosen two bolts (C) and jam nut (D).
d. Turn nut (E) clockwise to raise auger and
increase pan/draper clearance.
e. Repeat for other end of auger.
f. Check clearances and re-adjust as required.
g. Tighten bolts (C) and jam nut (D) on both ends
of auger.
7.4 STORAGE
Do the following at the end of each operating
season:
a. Clean the adapter thoroughly.
CAUTION
Never use gasoline, naphtha or any volatile
material for cleaning purposes. These
materials may be toxic and/or flammable.
b. Store the machine in a dry, protected place if
possible. If stored outside, always cover with a
waterproof canvas or other protective material.
c. If machine is stored outside, remove draper and
store in a dark, dry place.
d. Lower adapter onto blocks to keep off the
ground.
e. Repaint all worn or chipped painted surfaces to
prevent rust.
f. Lubricate the adapter thoroughly, leaving
excess grease on fittings to keep moisture out
of bearings. Apply grease to exposed threads,
cylinder rods and sliding surfaces of
components. Oil sickle components to prevent
rust.
g. Check for worn or broken components and
repair or order replacement from your dealer.
Attention to these items right away will save
time and effort at beginning of next season.
h. Replace or tighten any missing or loose
hardware. Refer to Section 8.3, Recommended
Torques.
D
E
C
INCREASE CLEARANCE
DECREASE CLEARANCE
A
B