MacDon CA20 Operators Manual - Manual (Page 84)

MAINTENANCE/SERVICE
Form 169009 82 Model Year - 2009
c. Release grease zerk/lock (G) with a
screwdriver.
d. Rotate guard locking ring (H) counterclockwise
with a screwdriver until lugs (J) line up with
slots in guard.
e. Pull guard off drive-line.
f. Repeat above steps c. to e. for other drive-line
guard.
8.9.4 GUARD INSTALLATION
a. Slide guard onto drive-line and line up slotted
lug on locking ring (K) with arrow (L) on guard.
b. Push guard onto ring until locking ring is visible
in slots (M).
c. Rotate ring (K) clockwise with a screwdriver to
lock ring in guard.
d. Push grease zerk (G) back into guard.
e. Repeat steps a. to d. for other guard.
(continued next page)
M
K
L
K
H
G
H
J