MacDon CA20 Operators Manual User Manual
Page 22
ADAPTER AND JOHN DEERE 60, 70 SERIES
Form 169009
20
Model Year - 2009
h. Attach coupler (G) to combine as follows:
1. Handle (A) should be in the up position.
2. Clean mating surface of coupler and
position coupler (G) onto receptacle.
3. Pull handle (A) so that lugs on coupler are
engaged into handle and pull to full
horizontal position as shown.
4. Slide latch (H) to lock handle in position
and secure with lynch pin (J).
i. Open drive shield (M).
j. Rotate disc (K) on adapter drive-line storage
hook and remove drive-line from hook.
k. Attach shaft to combine output shaft (L) and
close drive shield.
l. If adapter is equipped with reel fore-aft header
tilt selector, connect harness (P) to combine.
m. Disengage both adapter float locks by moving
latch (O) away from adapter and moving lever
(P) at each lock to lowest position.
P
LOCK
UNLOCK
O
J
H
A
G
M
L
K
P