MacDon CA20 Operators Manual User Manual
Page 58
Advertising
FD70 HEADER/ADAPTER
Form 169009
56
Model Year - 2009
r. Attach electrical connector as follows:
1. Remove cover on receptacle.
2. Align lugs on connector with slots in
receptacle, push connector onto receptacle
and turn collar on connector to lock it in
place.
3. Attach cover to mating cover on combine
wiring harness.
s. Raise and lower header and reel a few times to
allow trapped air to pass back to the reservoir.
NOTE
It is not necessary to bleed the system by
loosening fittings.
t. Check float and if the header is level. If
adjustments are required, refer to Section 7.3.5
Header Float, and Section 7.3.6 Header
Levelling.
Advertising