MacDon CA20 Operators Manual - Manual (Page 12)

ADAPTER AND CASE IH 7010, 8010
Form 169009 10 Model Year - 2009
3. Remove coupler (L) from combine and
clean mating surfaces. Position onto
adapter receptacle (G) and push handle (K)
to engage coupler pins into receptacle.
4. Push handle to closed position until lock
button (J) snaps out.
g. Connect combine electrical cable (L) to adapter
as follows:
1. Open cover on adapter electrical receptacle
(M).
2. Remove electrical connector (L) from
storage cup on combine. Align lugs on
connector with slots in receptacle, push
connector onto receptacle and turn collar
on connector to lock it in place.
h. Rotate disc (N) on adapter drive-line storage
hook and remove drive-line from hook.
i. Pull back collar on end of drive line and push
onto combine output shaft (O) until collar locks.
j. Disengage both adapter float locks by moving
latch (P) away from adapter and moving lever
(Q) at each lock to lowest position.
J
L
G
K
M
L
M
N
Q
LOCK
UNLOCK
P
O