MacDon CA20 Operators Manual - Manual (Page 83)

MAINTENANCE/SERVICE
Form 169009 81 Model Year - 2009
8.9.2 DRIVE-LINE INSTALLATION
IMPORTANT
If combine output shaft splines match
adapter input shaft splines, ensure drive-
line is installed with longer guard at
adapter gearbox end.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Slide driveshaft in hook (E) so that disc (D)
drops to secure driveshaft.
b. Slide shield (B) over drive-line.
c. Locate drive-line quick disconnect onto adapter
gearbox shaft, pull back collar and slide onto
shaft until yoke locks onto shaft. Release the
collar.
d. Position shield (B) on gearbox and secure with
nuts (A).
e. Reconnect other end to combine if necessary.
8.9.3 GUARD REMOVAL
The main drive-line guard normally remains
attached to the drive-line. If removal is required
for maintenance, refer to illustration and
proceed as follows:
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
NOTE
The drive-line does not need to be
removed from the adapter in order to
remove the drive-line guard.
a. Rotate disc (D) on adapter drive-line storage
hook (E) and remove drive-line from hook.
b. Lift combine end of drive-line (F) from hook and
extend drive-line until it separates. Hold
adapter end of drive-line to prevent it from
dropping and hitting the ground.
(continued next page)
D
E
B
C
A
D
E
F