MacDon CA20 Operators Manual - Manual (Page 56)

FD70 HEADER/ADAPTER
Form 169009 54 Model Year - 2009
3. Shutdown engine and remove key.
4. Ensure hook (F) is securely attached.
h. Connect reel hydraulics matching coloured
plastic ties.
i. If multi-coupler is installed, connect reel
hydraulics as follows:
1. Push in lock button (H) and pull handle (J)
up to half open position.
2. Clean couplers.
3. Position coupler (K) from combine onto
receptacle and push handle (J) to engage
pins on coupler.
4. Push handle to closed position until lock
button (H) snaps out.
j. Secure header to adapter as follows:
CAUTION
Always connect top link before fully raising
header.
1. Raise adapter slowly, making sure adapter
legs engage in header legs. Raise header
fully, stop engine, and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s
Manual for instructions for use and storage
of header lift cylinder stops.
2. Install bolts (E), spacers and lock washers
removed at step e. to secure adapter arms
(L) to header legs (M).
IMPORTANT
Do not install bolt longer than 1½ inches
(38 mm).
3. Return stand (N) to storage position and
secure with pin (O).
(continued next page)
N
O
E
L
M
J
H
H
J
K