MacDon CA20 Operators Manual - Manual (Page 52)

FD70 HEADER/ADAPTER
Form 169009 50 Model Year - 2009
3. Rotate latch (A) with a 15/16 wrench on hex
(B) to raise feed deck so that bolt (C) can
be removed. Repeat for other side of feed
draper.
4. Rotate latches to lower adapter deck.
5. Remove chain (D) from hook. Rotate latch
back to original position and reinstall bolts
(C).
h. Engage the adapter float locks by lifting lever
(E) until it latches into the lock position.
NOTE
Stabilizer/Transport wheels can be used
in combination with the stand to support
header.
i. Lower stand (F) by removing pin (G). Reinstall
pin when stand at desired height.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s
Manual for instructions for use and storage
of header lift cylinder stops.
j. Disengage reel props, lower reel and raise
header fully. Stop engine, remove key, and
engage combine lift cylinder locks.
k. Remove bolt (H), washer, and spacer from leg
on both sides of adapter. Retain for later re-
installation.
l. Disengage lift cylinder locks and lower header
to blocks and allow the header wings to go into
full frown mode. Stop engine and remove key.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
(continued next page)
H
C
D A
A
B
S
LOCK
UNLOCK
F
G