MacDon CA20 Operators Manual User Manual
Page 86
MAINTENANCE/SERVICE
Form 169009
84
Model Year - 2009
8.10 AUGER
8.10.1 AUGER TINE REPLACEMENT
The CA20 Combine Adapters are fitted with
tines to accommodate a wide variety and sizes
of combines. Some conditions may require the
removal or addition of tines for optimal feeding
of the crop. In addition, tines that become worn
or damaged should be replaced. To simplify the
procedure, detach combine from adapter.
Refer to Section 5 Adapter
Attachment/Detachment On Combine.
8.10.1.1 Tine Removal
a. Remove screws (A) and remove access cover
(B).
b. From inside the auger, remove hairpin (C) and
pull tine (D) out of bushing (E).
c. From inside the auger, swivel tine away from
bushing, pull from plastic guide (F) and remove
from auger.
NOTE
If the sixth tine (D) opposite drive side is
being replaced, it also must be slipped off
drive tube (G). This particular tine cannot
be removed for normal operation.
d. Remove screws (H) securing plastic guide (F)
to auger and remove guide from inside auger.
e. Position cover (J) from inside auger over hole
and secure with screws (H). Coat screws with
loctite and torque to 75 in-lbf (8.5 N·m).
F
E
D
C
B
A
F
H
J
H
G
D