MacDon CA20 Operators Manual - Manual (Page 26)

ADAPTER AND JOHN DEERE 50 SERIES
Form 169009 24 Model Year - 2009
k. Open shield (F) on LH side of combine.
l. Rotate disc (G) on adapter drive-line storage
hook and remove drive-line from hook.
m. Pull back collar on end of drive line and push
onto combine output shaft (H) until collar locks.
n. Close drive shield (F) on combine.
o. If adapter is equipped with reel fore-aft/header
tilt selector, connect harness (J) to combine.
p. Disengage both adapter float locks by moving
latch (M) away from adapter and moving lever
(N) at each lock to lowest position.
G
J
N
LOCK
UNLOCK
M
H
F