MacDon CA20 Operators Manual - Manual (Page 18)

ADAPTER AND CASE 2300, 2500 SERIES
Form 169009 16 Model Year - 2009
5.2.2 DETACHMENT
a. Choose a level area. Position header slightly
above ground. Stop engine and remove key.
DANGER
To avoid bodily injury or death from fall of
raised machine, always engage lift cylinder
stops before going under header for any
reason. See your Combine Operator’s
Manual for instructions for use and storage
of header lift cylinder stops.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
b. Engage both adapter float locks by lifting lever
(C) at each lock until it latches into the lock
position.
IMPORTANT
If slow speed transport wheels are
installed, header may be detached in
either transport or field mode. If
detaching with wheel in field mode, set
wheels to storage or uppermost working
position. Otherwise header may tilt
forward so that re-attachment will be
difficult. Refer to D50 and D60 Harvest
Header / FD70 FlexDraper Operators
Manual.
IMPORTANT
If stabilizer wheels are installed, set
wheels to storage or uppermost working
position. Otherwise header may tilt
forward so that re-attachment will be
difficult. Refer to D50 and D60 Harvest
Header / FD70 FlexDraper Operators
Manual.
c. Open cover (D).
d. Pull back collar (E) on drive-line and pull
driveline off combine shaft. Close guard (D).
e. Slide driveline in hook (F) so that disc (G) drops
to secure driveshaft.
f. Disconnect wiring harness (H) and attach
covers on each plug.
g. If applicable, unplug AHHC wiring harness from
connector (H1).
(continued next page)
E
D
G
F
C
LOCK
UNLOCK
H
H1