MacDon CA20 Operators Manual - Manual (Page 47)

D50 & D60 HEADER/ADAPTER
Form 169009 45 Model Year - 2009
6.1.2 ASSEMBLY
The D50 and D60 Harvest Header can be
attached to the adapter from either field
configuration or transport configuration.
NOTE
Stabilizer/Transport wheels can be used
in combination with the stand to support
header.
a. Remove lynch pin and remove pin (C) from
each header leg. Temporarily store in safe
place for reinstallation.
b. If not installed, install vibration dampers on
ends of adapter arms as follows:
1. Locate damper (D) onto adapter arm (E).
2. Secure with spacer (F), bolt (G), washer,
and lock-washer.
c. Prop up center link (H) (hydraulic shown) with
pin or equivalent tool.
d. Lower combine feeder house so that adapter
arms (E) are aligned with header legs (J).
e. Slowly drive forward, again aligning adapter
arms and header legs.
f. Keep adapter arm (E) height just under the
header leg (J) to ensure adapter leg seats
properly in the header linkage supports.
IMPORTANT
Keep hydraulic hoses clear to prevent
damage when driving into header.
g. Continue forward until adapter arm contacts
stop in header leg. Raise adapter slightly.
(continued next page)
E
J
G
D
F E
H
C