MacDon CA20 Operators Manual - Manual (Page 80)

MAINTENANCE/SERVICE
Form 169009 78 Model Year - 2009
8.8.2 HYDRAULIC OIL FILTER
NOTE
Change hydraulic oil filter after the first 50
hours of operation and every 250 hours
thereafter. Part #151975 can be
obtained from your dealer.
To change the hydraulic oil filter, refer to
following illustrations and proceed as follows:
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Remove five screws (A) and remove panel (B).
b. Clean around filter head (C).
c. Remove spin-off filter (D) and clean gasket
surface of filter head.
d. Apply a thin film of clean oil to the gasket on
new filter.
e. Turn the filter onto the mount until gasket
contacts filter head. Tighten filter an additional
½ to ¾ turn by hand.
IMPORTANT
Do not use a filter wrench to install the
filter. Over-tightening can damage
gasket and filter.
f. Reinstall panel (B) with screws (A).
B
A
C
D