MacDon CA20 Operators Manual - Manual (Page 53)

FD70 HEADER/ADAPTER
Form 169009 51 Model Year - 2009
m. Disconnect center link as follows:
1. For hydraulic adjuster, lift release (M) and
latch it in up position.
2. Extend center link cylinder to disengage
hook from header.
3. Prop up center link with a pin or equivalent
tool.
n. Disconnect knife and draper drive hydraulic
hoses.
o. If quick disconnects are installed, disconnect as
follows:
1. Line up slot (N) in collar with pin (O) on
connector.
2. Push collar toward pin and pull connector to
disengage.
3. Install plugs or caps on hose ends (if
equipped).
p. Disconnect electrical connector by turning collar
counterclockwise and pulling connector to
disengage.
q. Store and secure hoses on adapter.
r. Disconnect reel hydraulics as follows:
1. Push in lock button (P) and pull handle (Q)
to release coupler (R).
2. Push handle down until button (P) snaps
out.
3. Store hoses over adapter frame.
s. Ensure header is on ground or supported by
wheels in transport mode.
(continued next page)
M
Q
P
R
DRAPER DRIVE
RETURN
ELECTRICAL
KNIFE DRIVE
CASE DRAIN
(DOUBLE KNIFE)
O
N