MacDon CA20 Operators Manual - Manual (Page 48)

D50 & D60 HEADER/ADAPTER
Form 169009 46 Model Year - 2009
h. Connect hydraulic center link as follows:
1. For hydraulic center link (option), extend
hook (K) and remove prop under link so
that base of hook rests on pin (L).
2. Operate header angle hydraulics to retract
hook until it engages pin and self-latches.
CAUTION
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
3. Shutdown engine and remove key.
4. Ensure hook (K) is securely attached.
5. Proceed to step m.
i. Connect mechanical center link as follows:
1. Shutdown engine and remove key.
2. Remove pin (N) and the prop under link.
3. Adjust length of link by turning barrel (O) to
align with header bracket.
4. Insert pin (N) and secure with lynch pin.
j. Connect reel hydraulics matching coloured
plastic ties.
k. If multi-coupler is installed, connect as follows:
1. Push in lock button (P) and pull handle (Q)
to full open position.
2. Clean couplers.
3. Position coupler (R) from combine onto
receptacle and push handle (Q) to engage
pins on coupler.
4. Push handle to closed position until lock
button (P) snaps out.
(continued next page)
N
O
L
K
P
Q
R
P
Q