MacDon CA20 Operators Manual - Manual (Page 36)

ADAPTER AND NEW HOLLAND
Form 169009 34 Model Year - 2009
h. Connect to receptacle on adapter as follows:
1. Open cover (J).
2. Push in lock button (K) and pull handle (L)
halfway up to open position.
3. Remove coupler (H) from storage location
on combine and clean mating surface of
coupler.
4. Position coupler onto adapter receptacle
(M) and push handle (L) to engage pins into
receptacle.
5. Push handle (L) to closed position until lock
button (K) snaps out.
i. Attach combine electrical connector (N) to
adapter as follows:
1. Remove cover on adapter electrical
receptacle (O).
2. Remove connector (N) from combine.
3. Align lugs on connector (N) with slots in
adapter receptacle (O) and push connector
onto receptacle. Turn collar on connector
to lock it in place.
j. Rotate disc (P) on adapter drive-line storage
hook and remove drive-line from hook.
k. Pull back collar on end of drive line and push
onto combine output shaft (Q) until collar locks.
l. Disengage both adapter float locks by moving
latch (T) away from adapter and moving lever
(U) at each lock to lowest position.
L
J
K
O
M
U
LOCK
UNLOCK
T
N
P
H
N
L
K
Q