MacDon CA20 Operators Manual - Manual (Page 17)

ADAPTER AND CASE 2300, 2500 SERIES
Form 169009 15 Model Year - 2009
7. Connect hose (Q) from combine to adapter
coupler (S).
8. Connect hose (R) from the adapter to the
combine coupler (T).
d. Connect adapter electrical harness (U) to
combine electrical connector, and if applicable
connect AHHC wire harness at U1.
e. Open guard (V) at combine output shaft.
f. Rotate disc (W) on adapter drive-line storage
hook and remove drive-line from hook.
g. Pull back collar on end of drive line and push
onto combine output shaft (X) until collar locks.
Close guard (V).
h. If adapter is equipped with reel fore-aft/header
tilt selector, connect harness (Y) to combine.
i. Disengage both adapter float locks by moving
latch (B) away from adapter and moving lever
(C) at each lock to lowest position.
W
X
V
Q
R
S
T
Y
U
U1
C
LOCK
UNLOCK
B