SATEC SA300 ezPAC Operation Manual - Manual (Page 34)

Chapter 3 Using the RDM Using the Menus
34 SA300 Substation Automation Unit
DOWN ARROW
DOWN ARROW - Scrolls options backwards or decrements a number in the active
window
Selecting Menus
To access the RDM menus, press the SELECT key. The MAIN menu is open as
shown at left. The MAIN menu entries are as follows:
• StA - Status Information Display (see Status Information Display above)
• OPS - Setup Options Menu (allows reviewing setups without changing)
• CHG - Setup Change Menu (allows changing setups)
To enter the Status Information Display:
1. If the StA window is not a current active window, use the SELECT key to
activate it.
2. Press the SELECT key to enter the Status Information Display
For viewing the RDM or the SA300 setup options:
1. Press the SELECT key to activate the OPS window.
2. Press the SELECT key to enter the Setup Options Menu.
To change the RDM or the SA300 setup, or to clear the accumulated values:
1. Press the SELECT key to activate the CHG window.
2. Press the SELECT key to enter the Setup Options Menu.
Entry to this menu can be password protected.
After entering either OPS or CHG menu, the list of setup menus is displayed in the
upper window as shown at left. Use the Up/Down keys to scroll through the menus.
Press ENTER to enter the selected menu.
Entering a Password
The setup menus can be secured by a user-defined 8 digits password. The device is
shipped with password protection disabled. To enable password protection or to
change a password, see
Access Control Menu .
If authorization is required, the Password menu appears as shown left.
To change the RDM or the SA300 setup, or to clear the accumulated values:
1. Set the first digit using the Up/Down arrow keys.
2. Press SELECT to advance to the next digit.
3. Set the other password digits in the same manner.
4. Press ENTER to confirm the password.
If the password entered is incorrect, you are returned to the previous menu.
Entering Numbers
To change a number in the active (flashing) window, use the Up/Down arrow keys. If
you press and release the arrow key, the value is incremented or decremented by
one. If you press and hold the key, the value in the window is updated approximately
twice per second. If you hold the key for more than 5 seconds, the position of the digit
being changed moves to the adjacent higher digit.
To accept the new value, press ENTER.
To abort changes, press ESC.
StA
CHG
OPS
rESEt
ESC
PASS
0000
0000
bASc
200.0
Pt