SATEC SA300 ezPAC Operation Manual - Manual (Page 61)

Chapter 7 Programming the SA300 Changing Port Settings
SA300 Substation Automation Unit 61
To change the port settings in your device, select desired port parameters, and then
click Send. For the available communication options, see Communication Setup
Menus in Chapter 3.
Setting Up the Local Network
To enter the setup dialog, select the device site from the list box on the PAS toolbar,
select Communications Setup from the Meter Setup menu, and then click on the
Network Setup tab.
To change the Ethernet settings in your device, select desired parameters, and then
click Send. For more information, see
Configuring the Network in Chapter 4.
Configuring eXpertPower Client
The SA300 has an embedded eXpertPower TM client that provides communications
with the eXpertPower TM server – the SATEC proprietary Internet services.
Connections to the eXpertPower TM server are handled on a periodic basis.
To enter the Setup dialog, select the site from the list box on the PAS toolbar, select
Communication Setup from the Meter Setup menu, and then click on the
ExpertPower Client Setup tab.