SATEC SA300 ezPAC Operation Manual - Manual (Page 43)

Chapter 4 Using HyperTerminal Connecting to the Device
SA300 Substation Automation Unit 43
6. From the File menu, select Save to save your settings for the
SA300. When you next open a session and the New Connection
dialog appears, click Cancel, select Open from the File menu, and
then double-click on your session file.
Opening a Terminal Session
Put the PROGRAM-RUN key on the SA300 to the PROGRAM position. The SA300
Terminal program is launched and prints a list of the available commands as follows:
SA300 Substation Automation Unit Ver. 10.03.21
Copyright (C) 2003, SATEC Ltd.
SA300 Terminal commands
-----------------------
h or ? - Display this text
b - Change the terminal baud rate
i - Display firmware information
password - Password setting
time [hh:mm:ss] - Time
date [dd/mm/yy] - Date
com[port] - Serial port settings
net - Current Network Addresses
ip - Network settings
log - Print network log
stat - Print network statistics
run net - Starts the network
run server - Starts the TCP server
stop net - Shut the network down
stop server - Shut the TCP server down
diag - Print device diagnostics
clrdiag - Clear device diagnostics
irig - Test IRIG-B GPS receiver signal
service - Enter service menu
reset - Reset the device
quit - Quit Terminal
You are prompted for the password to login, as in the following example:
Login password: *
>