Configuring the sequence-of-events recorder, Linking digital inputs to the soe log, Linking relay outputs to the soe log – SATEC SA300 ezPAC Operation Manual User Manual
Page 86: Linking setpoints to the soe log, Configuring the event recorder, Points into the event report. see, Configuring the, Event recorder, In chapter 8 for more information on
Chapter 8 Configuring Recorders
Configuring the Sequence-of-Events Recorder
86
SA300 Substation Automation Unit
To log setpoint operations, add the “Event log” action to the setpoint actions list. Put
the event log action at the beginning of the list to allow other recorders to use the
sequence number assigned to the event for cross-linking between records logged to
different files. When a setpoint event happens, the Event recorder logs all setpoint
conditions that caused the event and all setpoint actions performed in response to the
event.
Configuring the Sequence-of-Events Recorder
The Sequence-of-Events (SOE) recorder can log four types of events:
•
Digital input events
•
Relay output events
•
Fault events
•
Setpoint events
Each state transition on a source point (open/closed, start/end) is recorded as a
separate event. Fault events are recorded to the file by default. Others should be
individually enabled to be recorded to the SOE log.
To change the SOE log file size:
1. Select Memory/Log from the Meter Setup menu, and then click
on the Log Memory tab.
2. Double click on the SOE log file partition with the left mouse
button.
3. Select a file type.
4. Select the maximum number of records you want to be
recorded in the file.
5. Click OK, and then send your new setup to the device or save
to the device database.
Linking Digital Inputs to the SOE Log
To link a digital input to the SOE log, check the “SOE Log” box when configuring the
). If you linked a digital input to the Fault
recorder, it is automatically connected to the SOE log even if you leaved the “SOE
Log” box unchecked.
Linking Relay Outputs to the SOE Log
To link a relay output to the SOE log, check the “SOE Log” box when configuring the
Linking Setpoints to the SOE Log
To link a setpoint to the SOE log, add the “SOE Log” action to the setpoint actions list
when configuring the setpoint (see
).