Rockwell Automation 20L PowerFlex 700L Liquid-Cooled Adjustable Frequency AC Drive - Manual (Page 56)

3-8 Frame 3A and 3B Installation
PowerFlex 700L Frames 2, 3A, and 3B Liquid-Cooled AC Drives User Manual
Publication 20L-UM001E-EN-P
Figure 3.7 Frame 3A and 3B Power Module Minimum Mounting Clearances
Verifying Power Module Input Ratings Match Supplied Power
It is important to verify that plant power will meet the input power
requirements of the PowerFlex 700L drive’s Power Module circuitry. See
Appendix A for input power rating specifications. Make sure input power to
the drive corresponds to the drive nameplate voltage and frequency.
Equipment Lifting This section explains how to lift the equipment.
Lifting the Complete Drive
For the complete drive equipment, always hoist the cabinet using the lifting
angles provided with the equipment (see
Figure 3.8 ). Prior to placing the
complete drive equipment at its installation site, remove both the pallet and
101.6 mm
(4.0 in.)
Cabinet Surface
101.6 mm
(4.0 in.)
50.8 mm
(2.0 in.)
152.4 mm
(6.0 in.)
152.4 mm
(6.0 in.)
Cabinet Surface
!
ATTENTION: To guard against possible personal injury and/or
equipment damage, observe the following:
• Do not allow any part of the drive or lifting mechanism to
make contact with electrically charged conductors or
components.
• At no time should a person or their limbs be directly
underneath the items being lifted.
• Do not subject the load to high rates of acceleration or
deceleration.
• Inspect all lifting hardware for proper attachment before
lifting any drive unit.