Rockwell Automation 1560E SMC Flex Smart Motor Controller - Manual (Page 110)

8-2 Communications
1560E-UM050B-EN-P - June 2013
Human Interface Module (cont.) Keypad Description
The functions of each programming key are described below.
Table 8.B – Keypad Descriptions
Escape
Exit a menu, cancel a change to a parameter value,
or acknowledge a fault/alarm.
Select
Select a digit, select a bit, or enter edit mode in a
parameter screen.
Up/Down
Arrows Scroll through options increase/decrease a value,
or toggle a bit.
Enter
Enter a menu, enter edit mode in a parameter screen,
or save a change to a parameter value.
Note: If a human interface module is disconnected from the SMC-Flex
controller while the Logic Mask is set to 1, a “Coms Loss” will
occur.
Note: For ease of programming values, after using the Enter key to edit,
use the Sel key to jump to the digit that needs to be modified, then
use the arrow keys to scroll through the digits.
The Bulletin 20-HIM LCD interface modules may be used to program and
control the SMC-Flex controller. The human interface modules have two
sections: a display panel and a control panel. The display panel duplicates
the 3-line, 16-character backlit LCD display and programming keypad
found on front of the SMC-Flex controller. Refer to Chapter 4 for a
description of the programming keys; refer to Appendix E for a listing of
human interface module catalog numbers that are compatible with the
controller.
Note: Bulletin 20-HIM Rev3.002 or later must be utilized with the
SMC-Flex.
Note: Extension cables are available up to a maximum of 10 m in total
length.
Note: A maximum of two HIM modules can be installed.