Rockwell Automation 1560E SMC Flex Smart Motor Controller - Manual (Page 99)

Options
Overview
The SMC-Flex controller offers a variety of unique control programming
and communication options that provide enhanced capabilities. (See
Chapter 1 for brief descriptions of each option.)
Note: Only one option can reside in a controller.
Human Interface Module
The control buttons available with the Bulletin 20-HIM Human interface
modules are compatible with the SMC-Flex controller’s control options.
The following table details the functionality of each button with regards to
each option.
Notes: (1) The logic mask port must be enabled prior to initiating control
commands to the SMC-Flex controller. Refer to Control
Enable on page 2-16 for instructions.
(2) The control terminals must be wired according to
Figure 3.10 on page 3-10 and Figure 3.16 on page 3-16.
Option Action Operation
Standard
II
The green start button, when pressed, will
commence motor acceleration to full speed.
O O
The red stop button, when pressed, will
provide a coast stop, and/or reset a fault.
Soft Stop
Current Limit
Full Voltage
Linear Speed
Jog Jog
The jog button, when pressed, will initiate the
programmed maneuver.
II
The green start button, when pressed, will
commence motor acceleration to full speed.
O O
The red stop button, when pressed, will
provide a coast stop.
Preset
Slow Speed
Jog Jog
The jog button is not active for Preset Slow
Speed.
* Slow Speed cannot be operated via the
HIM.
Chapter
6
1560E-UM050B-EN-P - June 2013