Rockwell Automation 1560E SMC Flex Smart Motor Controller User Manual
Page 111
Communications
8-3
1560E-UM050B-EN-P - June 2013
The control panel provides the operator inteface to the controller.
II
Start
The green start button, when pressed, will begin
motor operation. (Proper setup of the HIM port is
required.
O
O
Stop
The red stop button, when pressed, will halt motor
operation and/or reset a fault.
Jog
Jog
Jog
The jog button is active only when a control option
is present. Pressing the jog button
The Bulletin 20-HIM interface module's stop push
button is not intended to be used as an emergency stop.
Refer to the applicable standards for emergency stop
requirements.
The external HIM has a similar programming operation
to the built-in programmer, but note that differences do
exist.
All other controls available with the various human interface modules are
non-functional with the SMC-Flex controller.
A T T E N T I O N
A T T E N T I O N
A T T E N T I O N
A T T E N T I O N