Rockwell Automation 1560E SMC Flex Smart Motor Controller - Manual (Page 124)

9-6 Troubleshooting
%
5-"
%.
0
Control Module Removal The control module is not intended for field repair. The entire module
must be replaced in the event of failure. The following procedure must be
followed before unplugging the control module.
1. Remove all power from the equipment.
To avoid shock hazard, ensure the main power has
been disconnected before working on the controller,
motor or control devices. Verify that all circuits are
voltage free using a hot stick or appropriate voltage
measuring device. Failure to do so may result in
burns, injury or death.
2. Make sure that the wires are properly marked and that the program
parameters are recorded.
3. Disconnect all control wires to control module.
4. Loosen the four control module screws.
5. Carefully rotate the module to the left, and unplug the five ribbon
cables from the interface board.
When removing the control module, make sure to hold
the module in place as the screws are removed, to avoid
strain on the ribbon cables.
To install control module, follow the reverse order for removal.
Note: The MV SMC-Flex must use firmware release 3.006 or later.
A T T E N T I O N A T T E N T I O N
S H O C K H A Z A R D S H O C K H A Z A R D