Rockwell Automation 1560E SMC Flex Smart Motor Controller - Manual (Page 59)

Installation 2-11
Important: For retrofit units (Bul. 1560E), the CEC and NEC require that
branch-circuit protection of the AC line input to the controller be provided
by a circuit breaker or motor starter. This function is included with a
Bulletin 1562E.
Important: The control and signal wires should be positioned at least
six (6) inches (150 mm) from power cables. Additional noise suppression
practices (including separate steel conduits for signal leads, etc.) are
recommended.
Bulletin 1503E
For 1503E, refer to applicable documentation from OEM for installation,
grounding, interlocking and wiring. This manual should be utilized in
conjunction with the OEM supplied documentation, and is suitable for
commissioning, programming, calibration, metering, serial communica-
tions, diagnostics, troubleshooting, and maintenance of a standard solid-
state controller.