Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 31)

31 Publication 1747-UM655B-EN-P - June 2007
Chapter
3
Hardware Setup
What This Chapter Contains This chapter describes how to set up the hardware for the example
application. The following table describes what this chapter contains
and where to find specific information.
Installing the 1770-KFD
Module Connect the RS-232 connector on the 1770-KFD communication
interface module to one of the serial ports on your computer
workstation (COM1). Connect the DeviceNet connector on the
1770-KFD module to a DeviceNet drop or trunk cable. You can make
this connection in several ways; for example, by using a DeviceNet
Quad Tap (catalog number 1492-DN3TW) as shown on page 45.
Topic Page
Installing the 1770-KFD Module 31
Installing the SLC 500 Processor 32
Installing the ControlNet RS-232 Interface
Module 35
Installing the 1747-SDN Module 40
Installing the RediSTATION Operator
Interface 43
Installing the Series 9000 Photoeye 44
How Your Network Will Look 45
To computer COM
1770-KFD RS-232 Interface
Module
DeviceNet Dropline or
Trunk Cable To DeviceNet Network