Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 72)

Publication 1747-UM655B-EN-P - June 2007
72 Communicating with the DeviceNet Network from Another Network
The Browse for network dialog appears. You see the drivers you
have configured on your system.
5. Highlight 1747-SDNPT-2, DeviceNet driver and click OK.
You receive the following prompt.
6. Click OK to upload the devices.
RSNetWorx for DeviceNet software begins browsing for network
devices.
The network displayed on your screen should look similar to the
one shown below when RSNetWorx for DeviceNet software is
finished browsing.
ATTENTION
Performing a pass-through browse via the Ethernet network
takes longer than browsing by using the 1770-KFD DeviceNet
driver as described in chapter 4.
Note that due to the time required, the pass-through method is
not suitable for configuring a network nor for real time
monitoring of your network devices.
TIP
If RSNetWorx for DeviceNet software fails to find a device,
check the physical connection to that device.