Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 79)

79 Publication 1747-UM655B-EN-P - June 2007
Chapter
6
Creating and Running the Example
Application Program
What This Chapter Contains This chapter describes the procedure to create, download, and run an
example ladder logic program to test the DeviceNet network. When
the processor is put into Run mode, pressing the START button on the
network’s RediSTATION operator interface will cause the red indicator
light to come on and stay on until the STOP button is pressed. Passing
an object in front of the photoeye will increment a counter.
Recall that you cannot directly communicate with the SLC 500
processor over the DeviceNet network. This chapter shows how to
download and run the program over a ControlNet, Ethernet, or Data
Highway Plus network.
The SLC 500 I/O chassis used for these examples was set up with the
following hardware.
The following table describes what this chapter contains and where to
find specific information.
Chassis Setup
Module Slot DH+
Address Ethernet
Address ControlNet
Address DeviceNet
Address
SLC 500 5/04
Processor
(1)
(1) Used for Data Highway Plus and ControlNet examples.
0 1 - - -
SLC 500 5/05
Processor
(2)
(2) Used for Ethernet example.
0 - 130.130.130.2 - -
1747-KFC15 1 - - 16 -
1747-SDN 2 - - - 0
Topic Page
Install the Software 80
Create the Example Application Program 80
Download and Run the Program 82