Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual User Manual
Page 34
Publication 1747-UM655B-EN-P - June 2007
34 Hardware Setup
DH+ Network Connection
See Chapter 5 for information on configuring the SLC 5/04 processor’s
DH+ communication.
Installing an Ethernet SLC 500 Processor (SLC 5/05 Processor)
In order to communicate with your SLC 500 processor over an
Ethernet network, you must install an Ethernet version of the
processor (SLC 5/05 processor, catalog numbers 1747-L551, 1747-L552,
or 1747-L553).
Connect channel 1 of the Ethernet SLC 5/05 processor to an Ethernet
hub by using 10 Base-T cable as shown below.
Ethernet Hub Connection
See Chapter 5 for information on configuring the SLC 5/05 processor’s
Ethernet communication.
Terminating
Resistor
Ethernet
Hub
RJ45 Connectors on Both
Ends of Cable (10Base-T)
to Host Platform
Ethernet Card
to SLC 5/05
Channel 1