Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual User Manual
Page 38
Publication 1747-UM655B-EN-P - June 2007
38 Hardware Setup
Refer to the SLC 500 ControlNet RS-232 Interface User Manual,
publication 1747-5.34, for information on setting and verifying the
1747-KFC15 and SLC 500 processor communication parameters.
Configuring the 1747-KFC15 Module’s ControlNet Node Address
The 1747-KFC15 modules’s ControlNet node address is set by rotary
switches S4 and S5 on the top of the module. Switch S5 sets the upper
digit of the address and S4 the lower. These switches can be turned by
hand while holding the module in the orientation illustrated below.
Switch Location
We set the ControlNet node address to 16 for the example application.
Switch Setting
Refer to Chapter 5 for more information on configuring ControlNet
communication for the example application.
S4
S5
Front of
Module
Back of
Module
S4
S5
Rotary Switches
30
40
50
60
70
80
90
00
10
20
3
4
5
6
7
8
9
0
1
2
ControlNet Node Address = 16