Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 42)

Publication 1747-UM655B-EN-P - June 2007
42 Hardware Setup
Connect the 1747-SDN Module to the DeviceNet Network
Follow these steps to connect your module to the DeviceNet network.
1. Turn off the network power supply.
2. Connect the DeviceNet drop line to the 10-pin linear plug.
Match the wire insulation colors to the colors shown on the
label.
3. Locate the DeviceNet port connector on the front of the module,
and insert the 10-pin linear plug into the connector.
ATTENTION
Do not wire the 1747-SDN module with the network power
supply on. Wiring the module with the network power supply
on may short your network or disrupt communication.
Module label shows wiring
color scheme.
10-pin
Linear Plug
DeviceNet
Drop Line