Rockwell Automation 1747-SDN SLC 500 DeviceNet Scanner Module User Manual - Manual (Page 44)

Publication 1747-UM655B-EN-P - June 2007
44 Hardware Setup
See Chapter 2 of the RediSTATION Operator Interface User Manual,
publication 2705-UM001, for complete information about setting the
DIP switches to configure the node address, data rate, output flash
rate, and output fault state.
Refer to the following illustration as you connect the RediSTATION
operator interface to the network.
The DeviceNet cable connects directly to the mini connector on the
top of the RediSTATION enclosure or through the conduit opening
(open style).
RediSTATION Connection
Installing the Series 9000
Photoeye Connect the photoeye to the network and configure the photoeye as
follows:
•
Node address: 9
•
Operating mode: Light Operate (default)
•
Communication rate: 500 Kbps
TIP
You do not need to disconnect incoming power from the
DeviceNet network before connecting the RediSTATION
operator interface.
Mini
Connector
DeviceNet
Cable
Open
Style