Rockwell Automation 1734-ACNR POINT I/O ControlNet Adapter User Manual - Manual (Page 17)

Publication 1734-UM008B-EN-P - August 2005
Install Your Adapter 2-5
Connect Programming
Terminals to the Network
via the NAP You can connect programming terminals to the ControlNet network
by connecting to the network access port (NAP), as shown in the
figure.
ATTENTION
Use the 1786-CP cable when connecting a
programming terminal to the network through NAPs.
Using a commercially available RJ-style cable could
result in possible network failures.
Module
Status
PointBus
Status
ControlNet A
Status
1734-ACNR
ControlNet B
Status
Field
Power
System
Power
A
B
0 2
Using 1784-PCC Communication Card and NAP
Programming Terminal
1784-PCC
1786-CP
(1)
POINT I/O
ControlNet
adapter
(1) The 1786-CP cable can be plugged into any ControlNet product’s NAP to provide
programming capability on the ControlNet network. A programming terminal connected
through this cable is counted as a node and must have a unique address.
43400
1734-ACNR