Select a communication module – Rockwell Automation 1734-ACNR POINT I/O ControlNet Adapter User Manual User Manual
Page 34
Advertising
Publication 1734-UM008B-EN-P - August 2005
4-4 Configure the Adapter
Select a Communication Module
1. Click on I/O Configuration on the left side of the dialog to
highlight it.
2. Right-click on I/O Configuration and choose New Module to see this
Select Module dialog.
3. Right-click on + next to Communications to expand, as in the
following dialog.
4. Choose the 1756-CNBR/D ControlNet Bridge.
Advertising