Rockwell Automation 1734-ACNR POINT I/O ControlNet Adapter User Manual - Manual (Page 31)

1 Publication 1734-UM008B-EN-P - August 2005
Chapter
4
Configure the Adapter
Chapter Objectives This chapter guides you through the steps required to configure your
1734 POINT I/O ControlNet adapter using ControlLogix. The chapter
contains procedures on how to:
• add modules to the I/O configuration
– select a controller
– select a communication module
– select an adapter
• add analog, digital, specialty, or other modules
• download the program to the controller
• configure the 1734-ACNR adapter
• schedule I/O module connections
• access the module data via the 1734-ACNR adapter
• change configuration data
• respond in the case of an overloaded 1734-ACNR adapter
Add Modules to the
I/O Configuration You must add modules to the I/O configuration before you begin to
configure them.
Select a Controller
1. Start RSLinx software.
You need the 1756-CNBR Series D ControlNet bridge to access
the 1734-ACNR adapter from the ControlLogix network.