Select upgrade firmware on terminal and click ok, Select network connection and click next – Rockwell Automation 2711P PanelView Plus Terminal User Manual User Manual
Page 199
Advertising
Publication 2711P-UM001J-EN-P - November 2009
199
Upgrade Firmware Chapter 8
2. Select Upgrade firmware on terminal and click OK.
3. Select Network connection and click Next.
Use the Ethernet and Serial connections only if the firmware
upgrade is unsuccessful.
4. Locate the terminal on your Ethernet network via its IP address.
Skip to step 6 if you found the terminal. If you do not see the
terminal, right-click the Ethernet driver and add the device to the
browse tree.
Advertising