Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 49)

Publication 2711P-UM001J-EN-P - November 2009 49
Power Connections Chapter 3
2. Gently pry the terminal block away from terminal to release the
locking mechanism.
Follow these steps to replace the terminal block.
1. Press terminal block base in first with block leaning outward.
2. Gently push the top of the terminal block back to the vertical
position to snap in locking tab.
700 to 1500 Terminals
The terminal block used by the 700 to 1500 terminals depends on the
series of the logic module and the power input type.
•
Series A to D, DC logic modules use a 3-position terminal block.
•
Series E or later, DC logic modules use a 2-position terminal
block.
•
All logic modules with an AC power input use a 3-position
terminal block.